 | AFM active filter media replaces sand & activated carbon |
| sewage effluent containerized system schematic activated sludge aeration small industrial & large systems |
|
|
AFM
(Active Filtration Media) is a simple media bed filtration system that replaces sand in sand filters. However AFM works a great deal better than sand and has many additional benefits; Basic qualities
Hydrocarbons, PCB`s & list 1 chemicals Hydrocarbons can often be treated by biofiltration, if this is practical then a fixed film reactor or a fluidized bed may be used. The effluent from the biofilters goes directly to AFM with no flocculation. The solids load from the biofilter will normally be below 200mg/l, however if the levels are higher then a simple inclined tube clarifier may be used. The important point is that we do not want to expose the discharged aerobic bacterial cell biomass to the anaerobic conditions in a humus tank. The specialized adapted bacteria in the system are important for the operation of the process, the AFM mfilter will capture these bacteria and return them to the bio-reactor. List 1 chemicals and bio-accumulated toxic substances will tend to become concentration in the bacterial cell biomass. If the biomass is exposed to anaerobic conditions in a humus tank, the bacteria may succumb, or leachate out the list 1 chemicals. By using AFM®, bypassing the humus tank and keeping the system aerobic. The discharge of list 1 toxic chemicals can be reduced by up to 90%. Heavy metals AFM will remove some heavy metals directly, however it is important that there is oxygen in the water to insure that the catalytic reactions will progress. In some situation it may be necessary to adjust the pH and use flocculation prior to AFM®filters. No-Phos has proved to be very efficient in this respect. Iron & Manganese a specific schematic for iron and manganese click here for details Phosphates Phosphate will form an insoluble precipitate with APF and to some degree with calcium. However when NoPhos is used the reactions are stoichiometric and a very high percentage of the phosphate will precipitate out of solution. The precipitate will have a positive charge and is easily removed by the high negative surface potential on AFM |
|
Quaternary Treatment After AFM filtration the water will be of a high quality, suitable in most cases for direct discharge. However it very pure water is required for a gray water recirculation system, or even drinking water treatment, then extra treatment will be required. The AFM system will have reduced most of the loading on the final Quaternary step and makes the installation and use of the following processes a much lower cost and practical proposition;
|